With the PulStar Remote app on your Apple Watch, you can control a session on your Mac from your wrist, without walking back to the computer.
What you can do from the watch
Change the force and the adjustment mode (Osseous, Specific, Myofascial or Point).
Change the rate in Specific mode, by turning the Digital Crown.
Step through the vertebrae queued for treatment with the Digital Crown. Soft tissue is the position after the last vertebra.
Switch between Analysis and Adjustment.
Follow the preload gauge as you apply pressure.
Double Tap, on watch models that support it, works like a click of the button on the PulStar impulse head.
Set up
Make sure the Mac and the watch (or its iPhone) are signed in to the same iCloud account, and Bluetooth is on for both.
On the Mac, choose PulStar > Preferences, click General, then turn on Allow control from Apple Watch. The status reads “Ready” when the Mac is waiting for the watch. The first time you turn it on, macOS asks whether PulStar can use Bluetooth. Click Allow: the watch can't reach the Mac without it.
Open PulStar Remote on the watch. It finds the Mac through iCloud and connects. No code is needed.
Keep the Mac nearby and awake, with PulStar open. The watch controls the Mac only during a session, and only while the PulStar device and impulse head are connected.
If the watch can't connect
The watch explains what is wrong and what to do. Common fixes:
The watch says
Do this
Sign in to iCloud
Sign the watch, or its iPhone, in to the same iCloud account as the Mac.
Enable on your Mac
Turn on Allow control from Apple Watch in PulStar Preferences on the Mac.
Mac not found
Bring the watch near the Mac, make sure the Mac is awake with PulStar open, then tap Search Again.
Reset Bluetooth pairing
On the watch, open Settings > Bluetooth and forget the Mac (restart the watch if it isn't listed), then search again.
Watch access was reset
Someone clicked Reset Watch Access on the Mac. Turn watch control back on there, then tap Find My Mac Again on the watch.
To disconnect every watch that has been paired with this Mac, click Reset Watch Access in PulStar Preferences. Each watch must then be paired again.
If PulStar can't use Bluetooth
If the status in Preferences reads “Bluetooth access is turned off for PulStar”, PulStar isn't allowed to use Bluetooth. This happens when Don't Allow was clicked when macOS asked. macOS asks only once, so allow it in System Settings:
In PulStar Preferences, click Allow Bluetooth in System Settings…. If you have just turned on Allow control from Apple Watch, you can click Open System Settings in the message that appears instead.
In Privacy & Security > Bluetooth, turn on PulStar.
Return to PulStar. Watch control starts on its own, and the status reads “Ready”. If it doesn't, quit PulStar and open it again.
If the status reads “Bluetooth is off”, turn on Bluetooth in Control Center or in System Settings > Bluetooth.